TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 936 of 1414
TM 9-2320-365-34-2 18-28 Change 2 18-4. DIGITIZATION KIT INITIAL INSTALLATION This task covers: a. Installation b. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-365-10). Batteries disconnected (TM 9-2320-365-20-3). Cab storage boxes removed (TM 9-2320-365-20-4). Seat belts removed (TM 9-2320-365-20-4) Small arms mounts removed (TM 9-2320-365-20-4) Rear boarding handles removed (TM 9-2320-365-20- 4) RH seat removed (TM 9-2320-365-20-4) Power distribution panel removed for access (TM 9- 2320-365-20-4) Kick panel removed (TM 9-2320-365-20-4) Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Goggles, Industrial (Item 25, Appendix B). Drill Electric, Portable (Item 18, Appendix B) Drill Set, Twist (Item 17, Appendix B) Machine Gun Ring Drill Stop (Item 9, Appendix D) Tools and Special Tools (Cont.) Clamp (2) (Item 10, Appendix B) Wrench, Torque (0-200 lb-in) (Item 81, Appendix B) Wrench Set, Socket (Item 75, Appendix B) Drill Stop Collar Set (Item 20.1, Appendix B) Materials/Parts Ties, Cable Plastic (Item 89, Appendix C) Rivet, Compression (4) (Item 250.1, Appendix F) Sealant (Item 64.1, Appendix C) Antiseize (Item 13.1, Appendix C) Personnel Required (2) Reference Material TB43-0242 a. Installation (1) Position RH template (1) on rear cab wall (2) with two screws (3). (2) Drill two 3/16” (5 mm) pilot holes at locations (4). (3) Remove two screws (3) and template (1) from rear cab wall (2). WARNING CAUTION Wear appropriate eye protection when drilling holes. Failure to comply may result in injury to personnel. Drill bit stop must be used to limit the depth of drill bit travel. Failure to comply may result in damage to cab.