TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 915 of 1414
TM 9-2320-365-34-2 (26) Remove 45-degree grease fitting (52) from support (12). (27) Install grease fitting (53) in support (12). NOTE • Use bolts P/N 12414307-142 and self-locking nuts P/N 12414308-025 on step (28). • Support will be installed with fitting facing down. (28) Position support (12) on pintle hook extension (37) with four bolts (11) and self-locking nuts (10). (29) Position pintle hook extension (37) in vise. (30) Tighten four self-locking nuts (10) to 196-240 lb-ft (265- 325 N·m). (31) Position pintle hook (8) in pintle hook extension (37) with washer (7) and nut (6). CAUTION Clearance between washer and support must be 0.003-0.017 in. (0.076-0.432 mm). Failure to comply may result in damage to equipment. (32) Adjust nut (6) until clearance is 0.003-0.017 in. (0.076- 0.432 mm) with alignment holes lined up between nut (6) and pintle hook (8). (33) Install cotter pin (5) in nut (6). Change 1 18-7