TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 897 of 1414
TM 9-2320-365-34-2 Change 2 16-40.3 (10) Remove drive shaft (10) from frame (11). (11) Position universal joint (12) on yoke (13) with two bearing cups (14) and four screws (15). (12) Tighten four screws (15). WARNING CAUTION NOTE Step (10) requires the aid of an assistant. NOTE • When correct torque is reached, bearing cap screw small hex head will brake off. • Perform the following step on kits equipped with screws P/N C5 H5 24-39. Do not use steel hammers to seat bearing cups in drive yokes. Failure to comply may result in injury to personnel or damage to equipment. Check bearing cups to ensure all needle bearings are in place prior to installation. Replace bearing cups if needle bearings are missing or out of place. Failure to comply may result in damage to equipment. NOTE • Wipe end of yoke bearing cores prior to installation. • There are two types of bearing cup, those with tabs and those without. Perform the following step on bearing cups not equipped with tabs.