TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 875 of 1414
TM 9-2320-365-34-2 16-6. POWER TAKE-OFF (PTO) REPLACEMENT/REPAIR This task covers: a. Removal b. Disassembly c. Cleaning/Inspection d. Assembly e. Installation f. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-365-10). Batteries disconnected (TM 9-2320-365-20-3). Hydraulic rotary pump removed (para 16-5). Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Wrench, Torque, 0-200 lb-in. (Item 81, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B) Pliers, Retaining Ring (Item 38, Appendix B) Pliers, Retaining Ring (Item 39, Appendix B) Press, Arbor, Hand Operated (Item 41, Appendix B) Goggles, Industrial (Item 25, Appendix B) Gloves, Rubber (Item 23, Appendix B) Crowfoot Attachment, Socket Wrench (Item 12.1, TM 9-2320-366-20 Appendix B) Sling, Cargo (Item 48, Appendix B) Materials/Parts Cap and Plug Set (Item 18, Appendix C) Gasket (Item 54, Appendix F) Materials/Parts Ties, Cable Plastic (Item 89, Appendix C) Sealing Compound (Item 75, Appendix C) Dispenser, Pressure Sensitive Adhesive Tape (Item 31, Appendix C) Packing, Preformed (2) (Item 193, Appendix F) Gasket (Item 50, Appendix F) Seal, Encased (2) (Item 267, Appendix F) Gasket (Item 49, Appendix F) Seal, Plain Encased (Item 271, Appendix F) Packing, Preformed (Item 187, Appendix F) Packing, Preformed (Item 186, Appendix F) Packing, Preformed (Item 185, Appendix F) Packing, Preformed (Item 184, Appendix F) Packing, Preformed (Item 183, Appendix F) Packing, Preformed (Item 213, Appendix F) Packing, Preformed (2) (Item 155.1, Appendix F) Rag, Wiping (Item 59, Appendix C) Solvent, Dry Cleaning (Item 81, Appendix C) Lubricating Oil, Engine (Item 45, Appendix C) Screw, Self-Locking (4) (Item 251.1, Appendix F) Personnel Required (2) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. Removal. NOTE • Remove plastic cable ties as required. • Tag electrical connectors and connection points prior to disconnecting. (1) Disconnect electrical connectors P216 (1) and P217 (2) from PTO (3). Change 1 16-27