TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 674 of 1414
TM 9-2320-365-34-2 14-4. REAR LEAF SPRING REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-365-10). Rear wheel removed (from side being replaced) (TM 9- 2320-365-10). Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 85, Appendix B) Jack, Dolly Type, Hydraulic (Item 31, Appendix B) Wrench Set, Socket (Item 74, Appendix B) Tools and Special Tools (Cont) Trestles, Motor Vehicle Maintenance (2) (Item 71, Appendix B) Goggles, Industrial (Item 25, Appendix B) Materials/Parts Nut, Self-locking (4) (Item 124, Appendix F) Nut, Self-locking (2) (Item 138, Appendix F) U-bolt (2) (Item 15.1, Appendix F) Personnel Required (2) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. Removal. NOTE Left and right side rear leaf springs are removed the same way. Right side leaf spring shown. (1) Place trestles under rear of vehicle. (2) Raise floor jack enough to take rear axle (1) weight off leaf spring (2). (3) Remove four self-locking nuts (3), washers (4), and two U-bolts (5) from leaf spring (2). Discard self-locking nuts and U-bolts. (4) Remove plate (6) from leaf spring (2). (5) Lower rear axle (1) until there is a gap between rear axle and leaf spring (2). 14-16 Change 1