TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 663 of 1414
TM 9-2320-365-34-2 Change 2 14-5 b. Installation (1) Install C-Clamp on leaf spring (1). (2) Position bolt (2) on leaf spring (1) with self-locking nut (3). (3) Tighten bolt to 69-79 lb-ft (90-110 N•m). (4) Position plate (4) on bolt (2). (5) Position two U-bolts (5), four washers (6), and self- locking nuts (7) on plate (4). (6) Tighten four self-locking nuts (7) to 200 lb-ft (271 N•m) to 390-510 lb-ft (529-692 N•m), in sequence shown. (7) Re tighten four self-locking nuts (7) in increments of 50 lb-ft (68 N•m) to 390-510 lb-ft (529-692 N•m), in sequence shown. (8) Apply sealant to threads of bolt (2). (9) Position spacer (8) and enhanced resilient mount (9) on bolt (2). (10) Tighten enhanced resilient mount (9) 1 1/2 turns after contact with plate (4). (11) Remove C-Clamp. NOTE • Vehicles S/N 11,438 through 13,302 were originally equipped with three leaf springs. When replacing a three leaf spring with a four leaf spring, both sides must be replaced. • Vehicles S/N 13,303 through 16,156 were originally equipped with standard resilient mounts attached with bolts and washers. If leaf spring has this configuration, perform Enhanced Resilient Mount Initial Install action (M18-12 linked) and upgrade all six resilient mount to kit P.N 57K2003.