TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 658 of 1414
TM 9-2320-365-34-2 14-2 Change 2 Section II. MAINTENANCE PROCEDURES 14-2. FRONT LEAF SPRING REPLACEMENT This task covers: a.Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-365-10). Front drive shaft removed (left side) (TM 9- 2320-365-20-3). Gravel deflector and gravel deflector extension removed (TM 9-2320-365-20-3). Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B) Wrench, Torque, 0-200 lb-in. (Item 81, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 85, Appendix B) Jack, Dolly Type, Hydraulic (Item 31, Appendix B) Tools and Special Tools (Cont) Trestles, Motor Vehicle Maintenance (2) (Item 71, Appendix B) Goggles, Industrial (Item 25, Appendix B) Wrench Set, Socket (Item 74, Appendix B) Socket, Left Front Leaf Spring U-Bolt (Item 8, Appendix D) Materials/Parts Nut, Self-Locking (4) (Item 124, Appendix F) Pin, Cotter (Item 229, Appendix F) Nut, Self-Locking (2) (Item 138, Appendix F) Grease, Automotive and Artillery (Item 36, Appendix C) U-bolt (Item 15.1, Appendix F) Personnel Required (2) a. Removal. (1) Deleted (2) Deleted (3) Remove wheel on side that leaf spring is being removed (TM 9-2320-365-10). WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. NOTE Vehicles S/N 11,438 through 13,302 were originally equipped with three leaf springs. When replacing a three leaf spring with a four leaf spring, both sides must be replaced.