TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 647 of 1414
TM 9-2320-365-34-2 13-18. FRAME MUFFLER SUPPORT BRACKET REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Muffler and heatshield removed (TM 9-2320-365-20- 3). 11K self-recovery winch (SRW) removed, if equipped (para 16-2). Angle bracket removed (RH side) (M1081) (para 13- 10). Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Wrench, Torque, 0-150 lb-in. (Item 79, Appendix B) Tools and Special Tools (Cont) Socket Set, Socket Wrench (Item 51, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B) Goggles, Industrial (Item 25, Appendix B) Wrench Set, Socket (Item 75, Appendix B) Materials/Parts Nut, Self-locking (Item 126, Appendix F) Nut, Self-locking (2) (Item 139, Appendix F) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. Removal. NOTE Front and rear frame muffler support brackets are removed the same way. Front frame muffler support bracket shown. (1) Remove self-locking nut (1), screw (2), and clamp (3) from frame muffler support bracket (4). Discard self- locking nut. (2) Remove two self-locking nuts (5), screws (6), and frame muffler support bracket (4) from frame rail (7). Discard self-locking nuts. 13-87