TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download

Page 580 of 1414

TM 9-2320-365-34-2 13-7. SHOCK MOUNT CROSSMEMBER REPLACEMENT (CONT) (10) Remove self-locking nut (38) and ring (39) from shock mount crossmember (21). Discard self-locking nut. CAUTION When removing bolts, continuous removal of collars is mandatory. Failure to comply will result in seizing of collar to bolt. (11) Remove four collars (40) and bolts (41) from shock mount crossmember (21). Discard collars and bolts. (12) Perform steps (4) through (11) on right side of shock mount crossmember. (13) Position valve panel (37) to gain access to shock mount crossmember (21). (14) Remove shock mount crossmember (21) from vehicle. b. M1078/M1079 Installation. NOTE • Left and right side of shock mount crossmember is installed the same way. Left side shown. • Steps (1) through (24) require the aid of an assistant. • Install plastic cable ties as required. (1) Position shock mount crossmember (1) on vehicle with four bolts (2) and self-locking nuts (3). (2) Tighten four self-locking nuts (3) to 210-225 lb-ft (285- 305 N·m). (3) Position ring (4) in shock mount crossmember (1) with self-locking nut (5). (4) Tighten self-locking nut (5) to 113-138 lb-ft (153-187 N·m). 13-20 Change 1