TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 575 of 1414
TM 9-2320-365-34-2 (3) Position bolt (4) and self-locking nut (5) in rear crossmember (1). (4) Tighten self-locking nut (5) to 210-225 lb-ft (285-305 N·m). (5) Perform steps (1) through (4) on right side of rear crossmember. (6) Position support (6) on rear crossmember (1) with four screws (7) and self-locking nuts (8). (7) Tighten four self-locking nuts (8) to 195-239 lb-ft (265- 325 N·m). (7.1) Apply coat of grease to shaft of pintle hook (9). (8) Install pintle hook (9) in rear crossmember (1) with washer (10) and nut (11). CAUTION Clearance between washer and support must be 0.003-0.017 in. (0.07-0.43 mm). Failure to comply may result in damage to equipment. (9) Adjust nut (11) until clearance is 0.003-0.017 in. (0.07- 0.43 mm) with alignment holes lined up between nut and pintle hook (9). (10) Install cotter pin (12) in nut (11). Change 1 13-15