TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 573 of 1414
TM 9-2320-365-34-2 13-6. REAR CROSSMEMBER REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Rear tension beam removed (para 13-5). Rear bumper removed (para 13-8). Rear spring rear bracket removed (para 13-9). Rear marker lights removed (TM 9-2320-365- 20-3). Rear gladhands removed (TM 9-2320-365-20- 3). Rear intervehicular 12 VDC (7 Pin) cable removed (TM 9-2320-365-20-3). Rear intervehicular 24 VDC (12 Pin) cable removed (TM 9-2320-365-20-3). Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 85, Appendix B) Wrench Set, Socket (Item 74, Appendix B) Goggles, Industrial (Item 25, Appendix B) Socket, Socket Wrench (TM 9-2320-365-20) Materials/Parts Pin, Cotter (Item 230, Appendix F) Nut, Self-locking (16) (Item 134, Appendix F) Bolt (2) (Item 6, Appendix F) Bolt (10) (Item 10, Appendix F) Grease, Automotive and Artillery (GAA) (Item 36, Appendix C) Personnel Required (2) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. Removal. (1) Remove cotter pin (1) from nut (2). Discard cotter pin. (2) Remove nut (2) and washer (3) from pintle hook (4). (3) Remove pintle hook (4) from rear crossmember (5). (4) Remove four self-locking nuts (6), screws (7), and support (8) from rear crossmember (5). Discard self- locking nuts. Change 1 13-13