TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 546 of 1414
TM 9-2320-365-34-2 Section II. MAINTENANCE PROCEDURES 12-2. STEERING GEAR REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-365-10). Cab raised (TM 9-2320-365-10). Radiator removed (TM 9-2320-365-20-3) Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 85, Appendix B) Wrench Set, Socket (Item 74, Appendix B) Vise, Machinists (Item 72, Appendix B) Pan, Drain (Item 36, Appendix B) Adapter, Socket Wrench (Item 2, Appendix B) Puller, Mechanical (Item 45, Appendix B) Tools and Special Tools (Cont) Jack, Dolly Type, Hydraulic (Item 31, Appendix B) Materials/Parts Cap and Plug Set (Item 18, Appendix C) Nut, Plain, Hex (Item 121, Appendix F) Nut, Self-Locking (6) (Item 134, Appendix F) Pin, Cotter (Item 227, Appendix F) Dispenser, Pressure Sensitive Adhesive Tape (Item 31, Appendix C) Personnel Required (2) WARNING Ensure engine is cool before performing maintenance. Failure to comply may result in injury to personnel. a. Removal. CAUTION • Ensure steering axle wheels are pointed straight ahead. Failure to comply may result in damage to equipment. • Cap or plug hydraulic hoses and fittings to prevent contamination of hydraulic system. Failure to comply may result in damage to equipment. (1) Place drain pan under vehicle. (2) Remove plug (1) and two metal ring seals (2) from power steering return hose (3). 12-2