TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 532 of 1414
TM 9-2320-365-34-2 10-16.2 Change 2 10-4. REAR AXLE DIFFERENTIAL CARRIER REPLACEMENT (CONT) (8) Remove drive shaft (6) from frame (7). (9) Position universal joint (8) on drive yoke (9) with two bearing cups (10) and four screws (11). WARNING CAUTION Check bearing cups to ensure all needle bearings are in place prior to installation. Replace bearing cups if needed bearings are missing or cut out of place. Failure to compy may result in damage to equipment. NOTE • Wipe end of yoke bearing bores prior to installation, • Step (8) requires the aid of an assistant. Do not use steel hammers to seat bearing cups in drive yokes. Failure to comply may result in injury to personnel or damage to equipment. NOTE There are two types of bearing cups, those with tabs and those without. Perform the following step on bearing cups not equipped with tabs.