TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 528 of 1414
TM 9-2320-365-34-2 10-14 Change 2 10-4. REAR AXLE DIFFERENTIAL CARRIER REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Rear axle shaft removed (TM 9-2320-365-20-3). Rear axle differential carrier drained (TM 9-2320-365- 20). Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Goggles, Industrial (Item 25, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B) Lift, Transmission/Differential (Item 32, Appendix B) Wrench Set, Socket (TM 9-2320-365-20) Pan, Drain (Item 36, Appendix B) Tools and Special Tools (Cont) Sling, Cargo (Item 48, Appendix B) Materials/Parts Sealant, Adhesive (Item 67, Appendix C) Screw (4) (Item 251.1, Appendix F) Personnel Required (2) a. Removal. (1) Lift tabs from two bearing cups (1). (1.1) Remove four screws (2) and two bearing cups (1) from drive yoke (3). Discard screws. (2) Slide drive shaft from side to side (4) and separate universal joint (5) from drive yoke (3). (3) Attach drive shaft (4) to frame (6). WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. NOTE Step (3) requires the aid of an assistant. NOTE There are two types of bearing cups, those with tabs and those without. Perform step (1) on bearing cups with tabs.