TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download

Page 527 of 1414

TM 9-2320-365-34-2 Change 2 10-13 (9) Tighten four screws (11). (9.1) Tighten four screws (11) to 26-35 lb-ft (35-47 N•m). (9.2) Fold tabs on four screws (11). (10) Apply lubrication to grease Fittings (TM9-2320-366- 20). c. Follow-On Maintenance. (1) Check differential oil level (TM 9-2320-365-20). (1.1) Lubricate drive shaft universal joint and slip yoke (TM 9- 2320-365-20-1). (1) Operate vehicle and check for proper operation (TM 9- 2320-365-10). (3) Shut down engine (TM 9-2320-365-10). (4) Check pinion seal for oil leaks. End of Task. CAUTION NOTE When correct torque is reached, bearing cap screw small hex head will break off. Alternately tighten screws. Perform the following step on kits equipped with shearhead screws. NOTE Perform the following two steps on bearing cups equipped with tabs. Grease must flow from all four seals. Failure to comply may result in damage to equipment.