TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 523 of 1414
TM 9-2320-365-34-2 Change 2 10-11 10-3. REAR AXLE DIFFERENTIAL PINION SEAL, YOKE SEAL AND DRIVE YOKE REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-365-10). Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Puller Kit, Mechanical (Item 44, Appendix B) Wrench Set, Socket, (Item 74, Appendix B) Multiplier, Torque Wrench (Item 35, Appendix B) Goggles, Industrial (Item 25, Appendix B) Hammer, Soft Head (Item 28, Appendix B) Socket, socket wrench (Item 67, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B) Tools and Special Tools (Cont) Sling, Cargo (Item 48, Appendix B) Driver, Front and Rear Differential Yoke Seal (Item 45, Appendix D) Driver, Differential Pinion Seal (Item 44, Appendix D) Holding Bar, Pinion (TM 9-2320-365-20) Materials/Parts Sealing compound (Item 75.2 Appendix C) Kit, Seal (Item 263.1, Appendix F) Nut, Self-Locking (Item 144, Appendix F) Screw (4) (Item 251.1, Appendix F) Personnel Required (2) a. Removal. (1) Lift tabs from two bearing cups (1). (1.1) Remove four screws (2) and two bearing cups (1) from drive yoke (3). Discard screws. (2) Slide drive shaft (4) from side to side and separate universal joint (5) from drive yoke (3). (3) Attach drive shaft (4) to frame (6). WARNING Wear appropriate eye protection when working under vehicle due the possibility of falling debris. Failure to comply may result in injury to personnel. NOTE Step (3) requires the aid of an assistant. NOTE There are two types of bearing cups. Those with tabs and those without. Perform the following step on bearing cups with tabs.