TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download

Page 519 of 1414

TM-9-2320-365-34-2 Change 2 10-8.1 (18.2) Remove drive shaft (22.1) from frame (22.2). (19) Position universal joint (23) on drive yoke (24) with two bearing cups (25) and four screws (26). (19.1) Tighten four screws (26) to 26-35 lb-ft (35-47 N•m). WARNING CAUTION Do not use steel hammers to seat bearing cups in drive yokes. Failure to comply may result in injury to personnel or damage to equipment. Check bearing cups in ensure all needle bearings are in place prior to installation. replace bearing cups if needle are missing or out of place. Failure to comply may result in damage to equipment. NOTE Wipe end of yoke bearing bores prior to installation. There are two types of bearing cups, those with tabs and those without. Perform step (19) on bearing cups not equipped with tabs. NOTE Perform step (19.1) on kits equipped with screws P/N C5 H5-24-39.