TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 516 of 1414
TM 9-2320-365-34-2 10-2. REAR AXLE ASSEMBLY REPLACEMENT (CONT) NOTE Perform steps (28) and (29) on replacement rear axle assembly. (28) Remove 10 protective covers (40) from rear axle assembly (3). (29) Remove nuts (41 and 42) and bracket (43) from rear axle assembly (3). NOTE Perform steps (30) and (31) on old rear axle assembly. (30) Install bracket (43) on rear axle assembly (3) with nuts (41 and 42). (31) Install 10 protective covers (40) on rear axle assembly (3). b. Installation. WARNING Rear axle assembly weighs approximately 1580 lbs (717 kgs). Rear axle assembly must be supported on a transmission/ differential lift during installation. Failure to comply may result in injury to personnel or damage to equipment. NOTE Left and right sides of rear axle assembly are installed the same way. Left side shown. (1) Position rear axle assembly (1) on transmission/ differential lift and secure with chain. (2) Install 90-degree fittings (2, 3, and 4) on front air chamber (5). 10-6 Change 1