TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 510 of 1414
TM 9-2320-365-34-2 Section II. MAINTENANCE PROCEDURES 10-2. REAR AXLE ASSEMBLY REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Rear stabilizer bar removed (TM 9-2320-365-20-3). Rear wheels removed (TM 9-2320-365-10). Air tanks drained (TM 9-2320-365-10). Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 85, Appendix B) Wrench Set, Socket (Item 74, Appendix B) Lift, Transmission/Differential (Item 32, Appendix B) Hammer, Hand, Soft Head (Item 28, Appendix B) Jack, Leveling Support, Vehicle (TM 9-2320-365-20) Tools and Special Tools (Cont) Sling, Cargo (Item 48, Appendix B) Materials/Parts Dispenser, Pressure Sensitive Tape (Item 31, Appendix C) Nut, Self-locking (4) (Item 136, Appendix F) Nut, Self-locking (8) (Item 124, Appendix F) Screw, Self-locking (8) (Item 251.1, Appendix F) U-bolt (4) (Item 15.1, Appendix F) Personnel Required (3) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. Removal. (1) Place trestles under rear of vehicle. (2) Disconnect axle breather tube (1) from 45-degree fitting (2). (3) Remove 45-degree fitting (2) from rear axle assembly (3). (4) Remove screw (4) from load spring (5). Discard lockwasher. (5) Disconnect load spring (5) from rear axle assembly (3). 10-2 Change 1