TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 500 of 1414
TM 9-2320-365-34-2 9-6. STEERING KNUCKLE MECHANISM REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-365-10). Front axle shaft removed (para 9-3). Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Goggles, Industrial (Item 25, Appendix B) Gloves, Rubber (Item 23, Appendix B) Indicator, Dial (Item 30, Appendix B) Multiplier, Torque Wrench (Item 35, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 85, Appendix B) Sling, Cargo (Item 48, Appendix B) Tools and Special Tools (Cont) Jack, Dolly Type, Hydraulic (Item 31, Appendix B) Tie Down, Cargo Aircraft (Item 64, Appendix B) Materials/Parts Pin, Cotter (Item 226, Appendix F) (left side) Pin, Cotter (Item 227, Appendix F) (right side) Nut, Self-Locking (Item 126, Appendix F) Seal, Non-metallic (2) (Item 261, Appendix F) Bearing, Washer, Thrust (Item 1, Appendix F) Rag, Wiping (Item 59, Appendix C) Dispenser, Pressure Sensitive Adhesive Tape (Item 31, Appendix C) Personnel Required (2) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. Removal. (1) Remove cotter pin (1), nut (2), and tie rod (3) from steering knuckle (4). Discard cotter pin. 9-22