TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 498 of 1414
TM 9-2320-365-34-2 9-20.2 Change 2 9-5. FRONT AXLE DIFFERENTIAL PINION SEAL, YOKE SEAL AND DRIVE YOKE REPLACEMENT (CONT) (8) Position universal joint (9) on drive yoke (4) with two bearing cups (10) and four screws (11). (8.1) Tighten four screws (11) to 26-35 lb-ft (35-47 N•m). WARNING CAUTION Do not use steel hammers to seat bearing cups in drive yokes. Failure to comply may result in injury to personnel or damage to equipment. Check bearing cups to ensure all needle bearings are in place prior to installation. Replace bearing cups if needle bearings are missing or out of place. Failure to comply may result in damage to equipment. NOTE • There are two types of bearing cups, those with tabs and those without. Perform the following step in bearing cups not equipped with tabs. • Wipe end of yoke bearing bores prior to installation NOTE Perform the following step on kits equipped with screws P/N C5H5-24-39.