TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 487 of 1414
TM 9-2320-365-34-2 Change 2 9-15 9-4. FRONT AXLE DIFFERENTIAL CARRIER REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-365-10). Cab raised (TM 9-2320-365-10). Tie-rod assembly removed (TM 9-2320-365-20-3). Front axle shafts removed (para 9-3). Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Goggles, Industrial (Item 25, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B) Tools and Special Tools Lift, Transmission/Differential (Item 32, Appendix B) Sling, Cargo (Item 48, Appendix B) Materials/Parts Sealant, Adhesive (Item 67, Appendix C) Screw (4) (Item 251.1, Appendix F) Personnel Required (2) a. Removal. (1) Lift tabs from two bearing cups (1). (1.1) Remove four screws (2) and two bearing cups (1) from drive yoke (3). Discard screws. (2) Slide drive shaft (4) from side to side and separate universal joint (5) from drive yoke (3). WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. NOTE There are two types of bearing cups, those with tabs and those without. Perform the following step on bearing cups with tabs.