TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 486 of 1414
TM 9-2320-365-34-2 9-14 Change 2 9-3. FRONT AXLE SHAFT AND SEALS REPLACEMENT (CONT) (4) Install outer seal (4) in spindle assembly (5). (5) Install spindle assembly (5) in steering knuckle (6).with two guide bolts. (6) Position 10 screws (7), washers (8), and brake assembly (9) on steering knuckle (6). (7) Tighten 10 screws (7) to 110-145 lb-ft (149-197 N• m). (8) Connect two brake hoses (10) to front brake air chambers (11). d. Follow-On Maintenance. (1) Install wheel bearing/CTIS seal (TM 9-2320-365-20-3). (2) Check oil level of front differential carrier (TM 9-2320- 365-20). (3) Check oil level of hub assembly (TM 9-2320-365-20). (4) Perform wheel toe-in adjustment (TM 9-2320-365-20-3). (5) Start engine (TM 9-2320-365-10). (6) Operate vehicle, checking for proper steering operation and excessive vibration (TM 9-2320-365-10). (7) Shut down engine (TM 9-2320-365-10). (8) Check for oil leaks around wheel end assembly. End of Task. NOTE Use the aid of an assistant to hold front axle shaft prior to installation of spindle assembly.