TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download

Page 478 of 1414

TM 9-2320-365-34-2 9-8.2 Change 2 9-2. FRONT AXLE ASSEMBLY REPLACEMENT (CONT) (14) Tighten four screws (18). (14.1) Tighten four screws (18) to 26-35 lb-ft (35-47 N•m). (14.2) Fold tabs on four screws (18). (15) Connect drag link end (19) to pivoting arm (20). (16) Position nut (21) on drag link end (19). (17) Tighten nut (21) to 140-170 lb-ft (190-230 N•m). (18) Install cotter pin (22) in nut (21). NOTE Perform the following step on kits equipped with shearhead screws. Alternately tighten screws. When correct torque is reached, bearing cup small screw hex head will break off. NOTE Perform the following two steps on bearing cups equipped with tabs.