TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 440 of 1414
TM 9-2320-365-34-2 7-18. TRANSMISSION ASSEMBLY REPLACEMENT (UNUSUAL CONDITIONS) (CONT) NOTE Perform steps (3) and (4) if pressure plate assembly was removed from transmission serial numbers prior to 6510032369. (3) Position pressure plate assembly (4) on transmission (2) with 20 bolts (5). (4) Tighten 20 bolts (5) to 18-22 lb-ft (24-30 N·m). WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. (5) Apply light coat of sealing compound to seating surface (6) on transmission (2). (6) Install gasket (7) on transmission (2). (7) Remove five bolts (8) from adapter housing module (9). NOTE Transmission lifting bracket is installed with lift top-dead center facing forward. (8) Position transmission lifting bracket on adapter housing module (9) with five bolts (8). (9) Tighten five bolts (8) to 42-50 lb-ft (57-68 N·m). 7-118 Change 1