TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 421 of 1414
TM 9-2320-365-34-2 7-17. ENGINE AND TRANSMISSION MOUNT BRACKET REPLACEMENT This task covers: a. LH Removal b. LH Installation c. RH Removal d. RH Installation e. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-365-10). M1079 van body removed (TM 9-2320-365-20-4). Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Goggles, Industrial (Item 25, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 85, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B) Wrench Set, Socket (Item 75, Appendix B) Tools and Special Tools (Cont) Jack, Dolly Type, Hydraulic (Item 31, Appendix B) 4x4x8 in. (20 cm) wooden piece Materials/Parts Nut, Self-locking (2) (Item 146, Appendix F) Sealant, Pipe (Item 67.1, Appendix C) Personnel (2) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. LH Removal. NOTE Hydraulic jack is used to support engine and transmission while LH engine and transmission mount bracket is being replaced. (1) Position hydraulic jack with 8 in. (20 cm) wooden block under transmission control valve module (1). (2) Raise hydraulic jack to apply pressure to transmission (2). Change 1 7-99