TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 42 of 1414
TM 9-2320-365-34-2 Section II. MAINTENANCE PROCEDURES 3-2. DRESSED ENGINE UNPACKING/PACKING This task covers: a. Unpacking b. Packing. INITIAL SETUP Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Wrench, Torque, 0-150 lb-in. (Item 79, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B) Sling, Multiple Leg (TM 9-2320-365-20) Sling, Engine and Transmission, Motor Vehicle (Item 49, Appendix B) Stand, Engine Transport (Item 59, Appendix B) Wrench Set, Socket (Item 75, Appendix B) Materials/Parts Rag, Wiping (Item 59, Appendix C) Tape, Duct (Item 84, Appendix C) Desiccant (5) (Item 26, Appendix C) Lockwasher (41) (Item 104, Appendix F) Gasket (Item 29, Appendix F) Personnel Required (2) a. Unpacking. WARNING Ensure all pressure is released from engine container. Failure to comply may result in injury to personnel. (1) Depress and hold air release button (1) on engine container breather valve (2) until all pressure is released. WARNING Engine container cover weighs approximately 130 lbs (59 kgs). Attach a suitable lifting device prior to unpacking. Failure to comply may result in injury to personnel or damage to equipment. (2) Remove 24 nuts (3), lockwashers (4), and screws (5) from engine container cover (6). Discard lockwashers. NOTE Step (3) requires the aid of an assistant. (3) Lift engine container cover (6) from engine container base (7). (4) Remove gasket (8) from engine container base (7). Discard gasket. 3-2