TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 389 of 1414
TM 9-2320-365-34-2 7-10. CONTROL VALVE MODULE REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-365-10). Front drive shaft removed (TM 9-2320-365-20-3). Transmission oil filters removed (TM 9-2320-365-20- 3). Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B) Wrench, Torque, 0-150 lb-in. (Item 79, Appendix B) Jack, Dolly Type, Hydraulic (Item 31, Appendix B) Goggles, Industrial (Item 25, Appendix B) Tools/Special Tools (Cont) Wrench Set, Socket (Item 75, Appendix B) Materials/Parts Screw, Cap, Hex Head (3) (M10x1.5x55) (Item 77, Appendix C) Nut, Self-Locking (2) (Item 146, Appendix F) Seal (Item 260, Appendix F) Gasket (Item 36, Appendix F) Lubricating Oil, Gear (Item 49, Appendix C) Personnel Required (2) WARNING • Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. • Ensure exhaust system is cool before performing maintenance. Failure to comply may result in injury to personnel. a. Removal. (1) Remove self-locking nut (1) from clamp (2). Discard self-locking nut. (2) Disconnect lower exhaust pipe (3) from muffler (4). (3) Remove clamp (2) from lower exhaust pipe (3). Change1 7-67