TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 376 of 1414
TM 9-2320-365-34-2 7-7. STATIONARY CLUTCH SOLENOID ASSEMBLY REPLACEMENT/REPAIR (CONT) WARNING Use care when removing valve body parts retained by retaining pins. Valve body parts are under tension and can act as projectiles when released. Failure to comply may result in injury to personnel. (3) Remove retaining pin (4), stop (5), spring (6), and valve (7) from clutch valve body (2). CAUTION Retaining pins must be removed from bottom of solenoid body. Failure to comply may result in damage to equipment. (4) Remove three retaining pins (8), solenoids (9), regulating valves (10), and springs (11) from clutch valve body (2). (5) Remove three preformed packings (12 and 13) from solenoids (9). Discard preform packings. c. Cleaning/Inspection. WARNING • Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well-ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I Dry Cleaning Solvent is 100° F (38° C) and for Type II is 130° F (50° C). Failure to comply may result in serious injury or death to personnel. • If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical help. If dry cleaning solvent contacts skin or clothes, flush with cold water. If dry cleaning solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in serious injury or death to personnel. (1) Clean all metal parts with dry cleaning solvent. 7-54