TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download

Page 356 of 1414

TM 9-2320-365-34-2 7-36 Change 2 7-4. TRANSMISSION ASSEMBLY REPLACEMENT (USUAL CONDITIONS) (CONT) (50) Position six bolts (57) in flexplate (58). (51) Tighten six bolts (57) to 25-29 lb-ft (34-39 Nm). (52) Install plug (59) in flywheel housing (60). (53) Position 12 bolts (61) in flexplate (58). (54) Tighten 12 bolts (61) to 18-22 lb-ft (24-30 Nm). (55) Position gasket (62) and flywheel cover (63) on flywheel housing (60) with four washers (64) and screws (65). (56) Install gasket (62), flywheel cover (63), and transmission oil cooler hose bracket (66) on flywheel housing (60) with four washers (64) and screws (65). (57) Tighten four screws (65) to 22-26 lb-ft (30-35 Nm). NOTE Perform steps (50) through (52) on vehicle serial number 1478 and higher. Steps (50) and (51) require the aid of an assistant. During installation of flexplate bolts, access each flexplate bolt by turning alternator pulley through a series of short NOTE Perform steps (53) and (54) on vehicle serial number 0001 through 1477. Steps (53) and (54) require the aid of an assistant. During installation of flexplate bolts, acc- ess each flexplate bolt by turning alternator pulley through a series of short arcs. NOTE Perform steps (55) and (56) on vehicles equipped with transmission oil cooler tubes. NOTE Perform step (56) on vehicles equipped with transmission oil cooler hoses.