TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 276 of 1414
TM 9-2320-365-34-2 6-5. TRANSMISSION TURBINE SPEED SENSOR REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Control valve module removed (para 7-10). Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Wrench, Torque, 0-150 lb-in. (Item 79, Appendix B) Wrench Set, Socket (Item 75, Appendix B) Tools and Special Tools (Cont) Multimeter, Digital (Item 34, Appendix B) Goggles, Industrial (Item 25, Appendix B) Gloves, Rubber (Item 23, Appendix B) Materials/Parts Rag, Wiping (Item 59, Appendix C) Solvent, Dry Cleaning (Item 81, Appendix C) a. Removal. (1) Disconnect wiring harness connector (1) from turbine speed sensor (2). (2) Remove two screws (3) and turbine speed sensor (2) from control valve module (4). b. Installation. NOTE Handle parts carefully to prevent damage. (1) Position turbine speed sensor (2) on control valve module (4) with two screws (3). (2) Tighten two screws (3) to 108-120 lb-in. (12-14 N·m). (3) Connect wiring harness connector (1) to turbine speed sensor (2). c. Follow-On Maintenance. Install control valve module (para 7-10). End of Task. 6-32