TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 220 of 1414
TM 9-2320-365-34-2 4-7. FUEL CONTROL LINKAGE REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-365-10). Rocker arm assemblies removed (para 3-12). Tools and Special Tools Tool Kit, Intl. Comb. Eng. (TM 9-2320-365-20) Wrench, Torque, 0-150 lb-in. (Item 79, Appendix B) Tools and Special Tools (Cont) Adapter, Socket Wrench, (Item 1, Appendix B) Socket Wrench Attachment, Screwdriver (TM 9-2320- 365-20) Hammer, Hand Soft Head (Item 28, Appendix B) Tool Kit, Genl Mech (Item 68, Appendix B) Wrench Set, Socket (Item 75, Appendix B) Materials/Parts Lubricating Oil, Engine (Item 46, Appendix C) a. Removal. (1) Remove clip (1) from adapter sleeve (2). CAUTION Do not use hard-jawed pliers or screwdriver to move sleeve. Failure to comply may result in damage to equipment. (2) Slide adapter sleeve (2) in cylinder head (3). WARNING Use care when removing retaining rings. Retaining rings are under tension and can act as projectiles when released. Failure to comply may result in injury to personnel. (3) Remove retaining ring (4) and clevis pin (5) from governor linkage (6). 4-32