TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 135 of 1414
TM 9-2320-365-34-2 Change 2 3-87 3-11. FLYWHEEL HOUSING REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Starting motor removed (TM 9-2320-365-20-3). Engine speed sensor removed (TM 9-2320-365-20- 3). Engine removed (para 3-3). Flexplate removed (para 3-10). Crankshaft rear seal removed (para 3-9). Oil pan removed (para 3-16). Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B) Materials/Parts Gasket Maker (Item 35.1, Appendix C) Screw, Self-locking (10) (Item 253.1, Appendix F) Personnel Required (2) a. Removal. (1) Remove bolt (1) from flywheel housing (2). (2) Remove two bolts (3) from flywheel housing (2). NOTE Step (3) requires the aid of an assistant. (3) Remove 10 self-locking screws (4) and flywheel housing (2) from engine (5). Discard self-locking screws. WARNING Flywheel housing weighs approximately 75 lbs (34 kgs). Attach a suitable lifting device prior to removal. Failure to comply may result in injury to personnel or damage to equipment.