TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download

Page 129 of 1414

TM 9-2320-365-34-2 3-9. CRANKSHAFT REAR SEAL REPLACEMENT This task covers: a. Removal b. Cleaning/Inspection c. Installation d. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine removed (para 3-3). Flexplate removed (para 3-10). Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Drill, Portable, Electric (Item 18, Appendix B) Drill Set, Twist (Item 17, Appendix B) Goggles, Industrial (Item 25, Appendix B) Inserter, Seal (Item 32, Appendix B, TM 9-2320-365-20) Tools and Special Tools (Cont) Puller Kit, Universal (Item 38, Appendix B, TM 9-2320-365-20) Wrench Set, Socket, (Item 74, Appendix B) Gloves, Rubber (Item 23, Appendix B) Tool, Distorter (Item 75, Appendix B, TM 9- 2320-366-20) Materials/Parts Seal, Plain Encased (Item 266, Appendix F) Solvent, Dry Cleaning (Item 81, Appendix C) Rag, Wiping (Item 59, Appendix C) a. Removal. WARNING Wear appropriate eye protection when drilling holes. Failure to comply may result in injury to personnel. (1) Drill three evenly spaced holes in seal (1). (2) Remove seal (1) from crankshaft (2). Discard seal. NOTE If crankshaft rear seal has not previously been replaced, a wear ring will not be installed. (3) Remove wear ring (3) from crankshaft (2). Change 1 3-81