TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 126 of 1414
TM 9-2320-365-34-2 3-8. CRANKSHAFT FRONT SEAL REPLACEMENT (CONT) WARNING Wear appropriate eye protection when drilling holes. Failure to comply may result in injury to personnel. (5) Drill three equally spaced holes in crankshaft front seal (10). (6) Remove crankshaft front seal (10) from crankshaft (8). Discard crankshaft front seal. b. Installation. CAUTION Crankshaft front seal must be installed with shipping sleeve in place. Failure to comply may result in damage to equipment. (1) Install crankshaft front seal (1) on crankshaft (2). (2) Position seal installer and plate (3), on crankshaft (2) with four washers (4) and screws (5). NOTE Front seal is properly seated when recessed into front housing 0.08-0.12 in. (0.20-0.30 cm). (3) Measure distance from surface of crankshaft front seal to surface of front housing. (4) Tighten four screws (5) on plate (3). 3-78