TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 1252 of 1414
TM 9-2320-365-34-2 D-23. BATTERY 12V CABLE ASSEMBLY 12378512 (CONT) w. Crimp lug terminal (12b) to end of cable (11b). x. Insert end of cable (11b) into lug terminal (4). Make sure lug terminals are turned so stamped marks on lug terminal sides can be seen when battery 12V cable assembly is installed on vehicle battery. See battery layout in Figure D-46. Battery 12V Cable Assembly. y. Crimp lug terminal (4) to end of cable (11b). z. Insert end of cable (1) into lug terminal (12a). za. Crimp lug terminal (12a) to end of cable (1). zb. Install lug terminal (5) on end of cable (1). Make sure lug terminal is turned so stamped marks on lug terminal sides can be seen when battery 12V cable assembly is installed on vehicle battery. See battery layout in Figure D-46. Battery 12V Cable Assembly. zc. Apply thermoplastic adhesive filler (10) to eight sleevings (9). zd. Seal terminals sleevings (9) over crimp on lug terminals (5) and lug terminals (3, 4 12a and 12b) using thermal heat gun to dry thermoplastic adhesive filler. D-24. BATTERY GROUND CABLE ASSEMBLY 12378575 Make the Battery Cable Assembly from electrical cable, lug terminals, and sleeves according to the following steps. Refer to the following parts list and Figure D-47. Battery Ground Cable Assembly for details. Refer to specification Mil-B-43436 for requirements. Item Part Number Material Description Size Qty in. mm 1 12378873-050 Electrical cable 2 AWG 50.4 1280 1 2 12378873-050 Electrical cable 2 AWG 11.8 300 1 3 12414644-002 Negative Terminal 1 4 12414644-004 Negative Terminal 1 5 M20659-120 Terminal, Lug 1 6 M43436/1-3 Band, Marker 1 7 12414663-006 Sleeve, Band Marker 1.0 25.4 2 8 M23053/5-210C Sleeve, Cable 1.0 25.4 2 9 M23053/4-3050 Sleeving 1.0 25.4 4 10 12414580 Adhesive Thermoplastic A/R D-52 D-52