TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 1230 of 1414
TM 9-2320-365-34-2 D-16. SPREADER BAR Make the Spreader Bar for cab removal from steel channel stock and round rod stock according to the following steps. Refer to the parts list table and figure for details. Item Part Number Material Description Size Qty 1 N/A 5 inch Channel, steel, ASTM A-36 78.0 in. (1981 mm) X 5.00 in. (127 mm) X 1.75 in. (44 mm) X 0.38 in. (9.6 mm) thick 1 2 N/A Rod, steel, ASTM A-36 29.0 in. (736 mm) X 1.00 in. OD (25.4 mm) 1 3 N/A Rod, steel, ASTM A-36 13.0 in. (330 mm) X 1.00 in. OD (25.4 mm) 2 Figure D-26. Spreader Bar Layout a. All dimensions are in inches (millimeters). b. Heat and bend lift rod (2) to dimensions shown in Figure D-26. Spreader Bar Layout. c. Heat and bend two guide rods (3) to dimensions shown in Figure D-26. Spreader Bar Layout. d. Cut lift rod (2) and guide rods (3) to final dimensions shown in Figure D-26 Spreader Bar Layout. e. De-burr and remove sharp edges. D-30 D-30