TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download

Page 1158 of 1414

TM 9-2320-365-34-2 23-2. FRONT AXLE DIFFERENTIAL CARRIER REPAIR (CONT) NOTE Perform steps (38) and (39) only if a new pinion drive and drive gear set were installed. If old pinion drive and ring gear set is installed, go to step (40). The pinion cone variation number can be either 0.001 in. or 0.01 mm. For example, PC +4 equals +0.004 in., PC -.05 mm equals -0.05 mm. (38) If pinion cone variation number recorded in step (15) of disassembly is negative, subtract it from the thickness of the shims. If number is positive, add it to the thickness of the shims. Refer to Table 23-2 Pinion Cone Variation Chart. NOTE The value obtained from step (38) is the thickness of the new shims to be installed. Use as many shims as required to obtain the value from step (38). (39) If pinion cone variation number recorded in step (19) of assembly is negative, subtract it from value of the thickness of the shims. If number is positive, add it to the thickness of the shims. Refer to Table 23-2 Pinion Cone Variation Chart. Table 23-2. Pinion Cone Variation Chart PINION CONE VARIATION NUMBER EQUIVALENT MEASUREMENT PC +1 through PC +9 +0.001 in. through +0.009 in. +1 through +9 PC -1 through PC -9 -0.001 in. through -0.009 in. -1 through -9 PC +.01 mm through +.09 mm +0.01 mm through +0.09 mm +.01 mm through +.09 mm PC -.01 mm through PC -.09 mm -0.01 mm through -0.09 mm -.01 mm through -.09 mm 23-16