TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 1112 of 1414
TM 9-2320-365-34-2 21-14. C6 CLUTCH HOUSING ASSEMBLY REPAIR (CONT) NOTE Replace any part that fails visual inspection or size measurements requirements. (2) Inspect sleeve (1) for excessive wear. (3) Inspect bushing (2) for excessive wear. Maximum inside diameter is 1.424 in. (3.617 cm). (4) Inspect C6 drive hub (3) for pitting, damage, and indication of wear on splines. (5) Inspect C6 friction plates (4) for wear. Minimum thickness is 0.145 in. (3.638 mm). Maximum bend 0.016 in. (0.406 mm), and measure oil groove depth (A), minimum oil groove depth is 0.008 in. (0.203 mm). (6) Inspect C6 reaction plates (5) for wear. Minimum thickness is 0.087 in. (2.210 mm). Maximum bend is 0.016 in. (0.406 mm). (7) Inspect C6 piston (6) to C6 clutch housing (7) tang groove wear. Maximum tang groove wear is 0.09 in. (0.22 cm). (8) Inspect C6 piston (6) for seal ring groove wear, burring, and broken tangs. (9) Inspect spring retainer (8) for missing and broken springs. (10) Inspect C6 backing plate (9) for scoring and burring. Minimum thickness is 0.311 in. (0.789 cm). Maximum bend is 0.016 in. (0.040 cm). 21-68