TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download

Page 1077 of 1414

TM 9-2320-365-34-2 b. Cleaning/Inspection. WARNING Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I Dry Cleaning Solvent is 100°F (38°C) and for Type II is 130°F (50°C). Failure to comply may result in injury or death to personnel. If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical help. If dry cleaning solvent contacts skin or clothes, flush with cold water. If dry cleaning solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. (1) Clean all metal parts with dry cleaning solvent. NOTE Replace any part that fails visual inspection or size measurement requirements. (2) Inspect bearing retainer (1) for cracks, burrs, scoring, and grooves. (3) Inspect gear (2) for cracks, missing or broken teeth, pitting, and any damage to sealring groove. (4) Inspect drive hub (3) for excessive wear on drive tangs and splines. (5) Measure drive hub (3) sealring end gap (A) for maximum depth of 0.045 in. (1.143 mm). 21-33