TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download

Page 1067 of 1414

TM 9-2320-365-34-2 (23) Remove thrust bearing (29) from clutch hub (30). (24) Remove C2 piston (24) from clutch hub (30). (25) Remove C1 piston (31) from C2 piston (24). (26) Remove sealring (32) from C1 piston (31). Discard sealring. (27) Remove sealring (33) from C2 piston (24). Discard sealring. (28) Remove two sealrings (34) from gear (30). Discard sealrings. (29) Remove bushing (35) from gear (30). b. Cleaning/Inspection. WARNING Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I Dry Cleaning Solvent is 100°F (38°C) and for Type II is 130°F (50°C). Failure to comply may result in injury or death to personnel. If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical help. If dry cleaning solvent contacts skin or clothes, flush with cold water. If dry cleaning solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. (1) Clean all metal parts with dry cleaning solvent. NOTE Replace any part that fails visual inspection or size measurement requirements. (2) Inspect spur gear (1) for broken teeth, pitting, and weld cracks. (3) Inspect bushing (2) for scoring and burrs. (4) Measure inside diameter of bushing (2), maximum inside diameter 2.801 in. (71.14 mm). 21-23