TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download

Page 1020 of 1414

TM 9-2320-365-34-2 20-5. CRANKSHAFT AND MAIN BEARINGS REPLACEMENT/REPAIR (CONT) (10) Tighten 14 bolts (8) an additional 1/4 turn. (11) Remove 14 bolts (8), washers (7), seven crankshaft main bearing caps (3) and main bearings (2) from cylinder block (6). (12) Measure largest width (A) of each bearing gage with chart contained with gage package. Clearance should be 0.003-0.006 in. (0.007-0.015 cm). (13) Discard bearing gage from seven main bearings (2) after recording clearance. (14) Perform steps (8) through (10) to install seven crankshaft main bearings caps (3). (15) Mount dial indicator on cylinder block (6). (16) Align dial indicator with crankshaft (1) and adjust indicator to read zero. (17) Rotate crankshaft (1) and observe end play reading. (18) End play must be 0.003-0.009 in. (0.007-0.023 cm). If end play exceeds tolerance replace thrust bearing in No. 6 main bearing journal (9). (19) Remove dial indicator from cylinder block (6). 20-34