TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 1013 of 1414
TM 9-2320-365-34-2 b. Cleaning/Inspection. (1) Remove gasket material and sealant from cylinder block (1) surface. WARNING High pressure steam may blow particles into eyes, may cause severe burns, and creates hazardous noise levels. Eye, skin, and hearing protection is required. Failure to comply may result in injury to personnel. (2) Steam clean cylinder block (1). WARNING Compressed air for cleaning purposes will not exceed 30 psi (207 kPa). Use only with effective chip guarding and personal protective equipment (goggles, shield, gloves, etc.). Failure to comply may result in injury to personnel. (3) Dry cylinder block (1) thoroughly with compressed air. NOTE Replace any part that fails visual inspection or size measurement requirements. (4) Inspect cylinder block (1) for cracks, evidence of overheating, and other damage. (5) Inspect two sleeves (2) for damage and corrosion. (6) Inspect four alignment dowels (3) for damage and corrosion. NOTE If any cylinder bore exceeds maximum allowable diameter, replace cylinder block. (7) Measure cylinder bore (4) of each cylinder. Maximum cylinder bore diameter is 4.1358 in. (10.504 cm). 20-27