TM-9-2320-365-34-2 LMTV Direct Maintenance Manual M1078 Series - Volume 2 Download
Page 1006 of 1414
TM 9-2320-365-34-2 20-3. CYLINDER HEAD REPAIR (CONT) NOTE The centerline of the injector sleeve bore in the cylinder head must be parallel to the centerline of the arbor press ram. (11) Position cylinder head (2) on arbor press so driver (6) is centered under arbor press arm. (12) Press swage assembly (4) in injector sleeve (3) until the bottom of driver (6) contacts top of guide. (13) Remove driver (6) from swage assembly (4). (14) Install reaction sleeve (7) and plate (8) over threaded stem of swage assembly (4). WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. (15) Apply sealing compound to threaded stem of swage assembly (4). (16) Install thrust bearing (9) on plate (8). (17) Install washer (10) on thrust bearing (9). (18) Install nut (11) on threaded stem of swage assembly (4). (19) Pull swage assembly (4) from cylinder head (2), using deep socket. 20-20