TM-9-2320-365-34-1 LMTV Direct Maintenance Manual M1078 Series - Volume 1 Download
Page 507 of 1334
TM 9-2320-365-34-1 Change 1 2-417 CONTINUITY TEST CAUTION NOTE Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to transfer case wiring harness external connector pin B. (3) Connect negative (-) probe of multimeter to transfer case wiring harness connector H socket B and note reading on multimeter. (4) If continuity is not present, replace transfer case wiring harness (para 8-2). (5) Connect positive (+) probe of multimeter to transfer case wiring harness external connector pin B. (6) Connect negative (-) probe of multimeter to all other pins in transfer case wiring harness external connector and note reading on multimeter. (7) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (8) If continuity is present, transfer case wiring harness is shorted replace transfer case wiring harness (para 8-2).