TM-9-2320-365-34-1 LMTV Direct Maintenance Manual M1078 Series - Volume 1 Download
Page 351 of 1334
Change 1 2-263 TM 9-2320-365-34-1 CONTINUITY TEST NOTE CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to internal wiring harness 24-pin connector pin C2. (3) Connect negative (-) probe of multimeter to internal wiring harness connector C socket B and note reading on multimeter. (4) If continuity is not present, replace transmission internal wiring harness (para 7-13). (5) Connect negative (-) probe of multimeter to all other pins in internal wiring harness 24-pin connector and note reading on multimeter. (6) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (7) If continuity is present, replace transmission internal wiring harness (para 7-13).