TM-9-2320-365-34-1 LMTV Direct Maintenance Manual M1078 Series - Volume 1 Download
Page 289 of 1334
Change 1 2-201 TM 9-2320-365-34-1 CONTINUITY TEST (11) Position two washers and screws in front grille. (12) Tighten screw to 48-60 lb-in. (5-7 N·m). (13) Tighten two screws to 24 lb-in. (3 N·m). (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector P119-M. (3) Connect negative (-) probe of multimeter to external wiring harness 24-pin connector pin A1 and note reading on multimeter. (4) If continuity is not present, replace transmission external wiring harness (para 6-7). (5) Connect positive (+) probe of multimeter to connector P119-M. (6) Connect negative (-) probe of multimeter to all other pins in connector P119 and note reading on multimeter. (7) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (8) If continuity is present, transmission external wiring harness is shorted; replace transmission external wiring harness (para 6-7). (9) Connect connector P119 to connector J119. (10) Position front grille on cab with washer and screw.