TM-9-2320-365-34-1 LMTV Direct Maintenance Manual M1078 Series - Volume 1 Download

Page 1084 of 1334

TM 9-2320-365-34-1 2-19. GENERAL DISASSEMBLY INSTRUCTIONS (CONT) CAUTION Self-locking fasteners that are loosened must be replaced, not tightened. b. Locking Parts. Replace all lockwashers, cotter pins and locknuts at time of reassembly. c. Expendable Parts. All gaskets, packings, and seals removed during repair must be discarded and replaced with new parts. d. Removing Seals. Be sure all traces of oil, gaskets and sealants are removed from components. When possible, use wood or plastic probes and scrapers to prevent damage to machined surfaces. CAUTION Do not use tape to close off fuel or oil openings. Sticky surface of tape can mix with fuel and oil and cause engine malfunctions. e. Parts Protection. To keep dust, dirt, moisture and other objects out of internal parts of systems or components, cap or tape all open tubes, hoses, air lines, fittings and components openings as soon as part is removed. Wrap all removed parts in clean paper or dip parts in preservation oil. 2-20. GENERAL CLEANING INSTRUCTIONS WARNING Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I Dry Cleaning Solvent is 100°F (38°C) and for Type II is 130°F (50°C). Failure to comply may result in serious injury or death to personnel. If personnel become dizzy while using Dry Cleaning Solvent, immediately get fresh air and medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. Never use fuel to clean parts. Fuel is highly flammable. Serious injury could result if fuel ignites during cleaning. a. Cleaning Solvents. Use only approved cleaning solvents to clean parts. Dry Cleaning Solvent P-D-680 (Item 80, Appendix C) is commonly used. Always work in a well-ventilated area. 2-984 2-984