TM-9-2320-365-34-1 LMTV Direct Maintenance Manual M1078 Series - Volume 1 Download
Page 1081 of 1334
TM 9-2320-365-34-1 TM 9-2320-365-34-1 TM 9-2320-365-34-1 TM 9-2320-365-34-1 TM 9-2320-365-34-1 WARNING Drop hydraulic pressure to zero before disconnecting any hydraulic line. Failure to comply may result in injury to personnel. Wear approved eye protection when performing pressure checks. Failure to comply may result in oil getting into eyes. If oil contacts eyes, seek medical attention immediately. Fuel and oil are slippery and can cause falls. Wipe up spilled fuel or oil with rags. Failure to comply may result in injury to personnel. NOTE Tag all hardware prior to removal. HYDRAULIC FLOW AND PRESSURE TEST (14) Disconnect and disassemble STE/ICE-R, hoses and adapters. (15) Install plug in S1 port. (1) Place drain pan under vehicle. (2) Remove plug from port S1 (on side of 11K self- recovery winch toward front of vehicle). (3) Connect STE/ICE-R (see test #50) to S1 port. (4) Start engine (TM 9-2320-365-10). (5) Attach stall load to winch cable (TM 9-2320-365-10). (6) Position PTO switch and WINCH POWER switch to ON (TM 9-2320-365-10). (7) Engage winch clutch (TM 9-2320-365-10). (8) Toggle WINCH IN/OUT switch to IN position and hold (TM 9-2320-365-10). (9) Perform STE/ICE test #50 and note pressure gage reading. (10) If hydraulic pressure at port S1 is below 210 psi (618 kPa), counterbalance valve is faulty. (11) Release load and retrieve cable (TM 9-2320-365-10). (12) Position WINCH POWER and PTO switches to OFF (TM 9-2320-365-10). (13) Shut down engine (TM 9-2320-365-10). 2-981/(2-982 Blank) 2-981/(2-982 Blank) 2-981/(2-982 Blank) 2-981/(2-982 Blank) 2-981/(2-982 Blank)