TM-9-2320-365-20-5 LMTV Unit Maintenance Manual M1078 Series - Volume 5 Download
Page 311 of 666
TM 9-2320-365-20-5 Change 2 20-481 20-84. M1078/M1081 S-280 SHELTER MODELS A, B, OR C TIEDOWN KIT INSTALLATION/REMOVAL This task covers: a. Installation b. Removal c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-365-10). Cargo bed side panels and stakes removed (TM 9-2320- 365-10). Tools and Special Tools Drill Set, Twist (Item 8, Appendix C) Drill, Portable, Electric (Item 7, Appendix C) Tap, thread, cutting (Item 40.3, Appendix C) Tap and Die Set, (Item 40.2, Appendix C) Tools and Special Tools (Cont) Tool Kit, Genl Mech (Item 44, Appendix C) Sling, Cargo (2) (Item 31, Appendix C) Materials/Parts Lockwasher (8) (Item 66.2, Appendix G) Nut, Self-Locking (4) (Item 143, Appendix G) Personnel Required (2) a. Installation. (1) Measure and mark a line (1) 1.25 in. (32 mm) down from upper RH corner of tiedown bracket (2). (2) Measure and mark a line (3) 4.4 in. (109 mm) from RH side of line (1). (3) Measure and mark a line (4) 4.72 in. (120 mm) from RH side of line (3). NOTE This paragraph applies to shelter models A, B, or C with an overall height of 83 1/2 to 89 in. (214 to 226 cm). If shelter height is below 83 1/2 in. (214 cm), shorten cable for proper removal of slack in turnbuckle assembly. NOTE • Perform steps (1) through (6) on tiedowns not originally modified. • All tiedowns are modified the same way. RH front tiedown shown. • Measurements will be taken from upper LH corner on LH tiedown bracket.